Feature:
1. [INSTANT HOT WATER] Electric water heaters can instantly provide continuous hot water at 30 celsius or higher without waiting for preheating or terrible temperature rises and drops.
2. [INTELLIGENT CONSTANT TEMPERATURE] Small size, fast heating, energy saving, temperature range of 30‑55 celsius , suitable for washing, hands, dishes, vegetables, face, and bath.
3. [EASY TO OPERATE] Equipped with digital display and touch control panel, easy to set the temperature, with a remote control, easy to adjust the temperature, you can also use the touch screen button.
4. [SAFE AND DURABLE] Multiple protection devices, each product has been strictly tested, and the internal water and electricity lines are designed for branch operation to avoid water leakage or scale accumulation.
5. [EASY INSTALLATION] Tankless electric water heater, simple and convenient to install. It is suitable for installation in household kitchens, toilets, showers, public toilets, etc.
Specification:
Item Type: Water Heater
Material: Aluminum Die Casting+PC+Brass
Weight: Approx. 1800g / 63.5oz
Model: LF-001A
Heating Body Material: Aluminum Die Casting
Power: 3000W
Frequency: 50-60HZ
Electric Wire: 2.08square meters
Waterproof Rating: IPX4
Remote Control Power Supply: 2 x AAA Batteries (Battery Not Included)
Temperature Range: 30-55 celsius
Product Size: Approx. 21x15x5.5cm / 8.3x5.9x2.2in
Water Source Pressure: 0.04-1.2MPa
Installation Environment Requirements: Kitchen, bathroom, toilet, shower room, wire requirements greater than 2.08m²; circuit breaker switch greater than 32 amps..
Package List:
1 x Water Heater4 x Screw4 x Expansion Tube1 x Manual1 x Remote Control (Battery Not Included)
Note:
Common faults and solutions:1. Check whether the power supply is normally energized, the indicator will light up to show the temperature when the power is on, and it will not light up if it is not energized.2. Under normal power on conditions, the water flow is turned on, press the middle switch key, the machine starts heating, and the water heater displays: set temperature, water flow, outlet temperature.3. If the temperature does not rise, there are 2 possibilities: one is that the temperature control switch inside the water heater has tripped (overheating protection switch), press the temperature control switch to recover. The other is the heating tube failure, just replace the heat tube .4. If there is no heating, the display shows the temperature, but the water flow and the set temperature are not displayed, indicating that the water flow has not passed through the water heater, or the water pressure is too low, or the installation direction is wrong. Note that the water inlet and outlet must be installed correctly. If the pressure is enough, the water does not heat up, then check the water heater inlet turbine, there may be dirt stuck in the turbine, causing the water heater to not start.5. It is recommended that the length of the water outlet pipe of the water heater should not exceed 3 meters. If it exceeds, there may be a water pressure difference due to the length of the water pipe, and the water pressure is not enough to start. (If the water tower is used in rural areas, the height of the water tower is required to be higher than 10 meters, so that the water pressure reaches the starting value)6. The display shows E1 over temperature, E4/E5 or temperature sensor failure, first turn off the power, run the machine with cold water, and then use it when it is powered on. Note that the water flow should not be too small in normal use.7. The heating tube failure displays E2, and t
Niet geleverd, dan geld terug
