Chlorine test-adjustment points:
Before use, please adjust the tester for the swimming pool water or hot spring water to be tested in the following order:
1. Use traditional liquid testing tools to test swimming pool water or hot spring water;
2. Record the chlorine gas reading for backup (1.5PPM);
3. No need to adjust the PH.
Find the adjustment point of the tester:
A. Put an AA 1.5 V battery (positive side up) in the battery slot of the handle.
B. Hold the tester in one hand and the test stick in the other.
C. Insert the cleaned metal rod into the water to the black position.
D. Use a metal rod to gently stir the water.
E. While keeping the metal rod in the water, turn the knob on the front of the watch toward CL until it can no longer move. Then slowly turn back to the right until the pointer points to the traditional
The position of the result measured by the liquid test tool (eg 1.5).
F. Remove the test rod from the water, being careful not to move the knob. The pointer will slide to the right and stop with a letter between A and E. This letter is the adjustment point.
Note: Before each test of chlorine gas, the meter must be adjusted to the “adjustment point”.
Test pH:
The recommended chlorine content for swimming pool water or hot spring water is 7.2 to 7.8
A) Leave the test stick in the water, and turn the knob toward the pH to make a beeping sound (the battery must be taken out when reading the pH value).
B) Wait for the pH reading after the pointer stops swinging.
C) Gently dry the test rod, insert it into the slot next to the tester, and store it.
Test the chlorine content:
The recommended chlorine content for swimming pool water or hot spring water is 1.2 to 1.7 ppm
A) Set the pointer to the "adjustment point" position.
B) Hold the tester in one hand and the test rod in the other, and insert the metal rod into the water to the black position. Take a reading after the pointer stops swinging.
C) Leave the test stick in the water and continue the pH test according to the instructions.
Specification:
1. Essential tools for swimming pools, saunas and hot springs
2. Ideal tool for simple measurement of pH and C12 values of water
3. No chemical composition, no more guesswork
4. Chlorine level in the safe measurement range: 1.2-1.7ppm
5. PH level within the safe measurement range: 7.2-7.8
6. Battery: Use 1 AA battery (not included)
Storage method:
In order to extend the service life of the swimming pool tester PC-101 and ensure measurement,
caution:
1. When not in use, please turn the knob to the closed position (in the direction of PH until it can no longer be moved).
2. Store in a cool, dry place, avoid direct sunlight.
3. Never immerse the test rod in any liquid other than swimming pool water and hot spring water.
4. Regularly check whether the battery is sufficient-the tester uses an "AA" 1.5 V alkaline battery
Packing list: 1 * water quality detector, English manual, blister
Niet geleverd, dan geld terug
